BACK TO INDEX 11.DAY                               BACK                            NEXT
 

For soldering the lower area of the shade nearly

the full length of the chain was needed.

That´s what my eyes see,  when sitting and working.
 
 
 

At 22:15  the last copper was tinned.

There was another 55 minutes to finish oll junctions of the lower area.
 

At 23:10 it was done. I picked the mold from the chain and put it upside down

on the working table.

There were some "Knubbel"  (lumps) in the lower ring area left.

I soldered this area smooth, that would give a little bit more stability, when

the shade comes off the mold.

BACK TO INDEX 11.DAY                             BACK                                    NEXT